Eurotherm 3116 PID Podręcznik Użytkownika Pobierz pdf (Strona 26)

3116 User Guide Part No. HA028005ENG Issue 2.0 May 04

ENG

Mnemonic Scrolling Display and description Range

TM.RES TIMER RESOLUTION selects hours or minutes (only when in Reset)

Hour

min

Hours

Minutes

THRES TIMER START THRESHOLD The timer will not run until the PV

becomes in range of the value set by this parameter. This value can

be changed when the timer is running.

OFF or 1 to 3000

OFF

Control OP goes

to zero

Dwel

Control continues

at SP1

END.T TIMER END TYPE The action of the timer when it has timed out can

be selected from Dwell (control continues at the setpoint), Off

(control outputs turn off), SP2 (control at setpoint 2). Can be changed

while the timer is running.

SP2

Go to SP2

SS.PWR SOFT START POWER LIMIT Sets the power limit during start up -100 to 100%

SS.SP SOFT START SETPOINT sets the threshold below which the power is

limited

Between SP.HI and SP.LO

DWELL SET TIME DURATION - can be adjusted while the timer is running.

This parameter only appears for a Dwell type timer.

0:00 to 99.59 hh:mm: or

mm:ss

T.REMN TIME REMAINING Time remaining to reach the set time 0:00 to 99.59 hh:mm: or

mm:ss

This section applies to Alarms only If an alarm is not configured the parameters do not appear

A1.--- - to

A4.---

ALARM 1 (2, 3 or 4) SETPOINT sets the threshold value at which an

alarm is detected. Up to four alarms are available and are only shown

if configured.

--- = the mnemonic for the alarm type which may be:-

SP.HI to SP.LO

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 39 40

Brak uwag

Eurotherm 3116 PID Podręcznik Użytkownika Strona 26