Eurotherm 3116 PID Podręcznik Użytkownika Pobierz pdf (Strona 16)

3116 User Guide Part No. HA028005ENG Issue 2.0 May 04

ENG

5.2 To Re-Enter Quick Code mode

If you need to re-enter the ‘Quick Configuration’ mode this can always be done by powering down the controller, hold

down the

button, then power up the controller. You must keep the button pressed until ‘code’ appears. You

must then enter a passcode using the

▲

▼

buttons. In a new controller the passcode defaults to 4. If an

incorrect passcode is entered you must repeat the whole procedure. You can then re-configure the controller through

the Quick Codes.

Note:- If the quick codes re-appear with decimal points between each character this means THE QUICK CODES

MAY NO LONGER BE VALID. This is because a parameter (not necessarily a Quick Code parameter) which is available in

the controller at a deeper level of access* has been altered. You can, however, re-adjust the Quick Codes again at this

point to re-configure the controller, (or proceed to

Yes

Exi T

state).

* The procedure for a full configuration is described in the 3116/3216 Engineering Handbook Part No. HA027986 which

may be downloaded from www.eurotherm.co.uk

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 39 40

Brak uwag

Eurotherm 3116 PID Podręcznik Użytkownika Strona 16